Xanthan gum and pectin as beverage stabilizers reduce the digestive enzyme hydrolysis of antioxidant and antihypertensive peptides obtained from a brewery byproduct.

An acidic beverage was formulated with xanthan gum (XG), pectin (P) and brewer spent grain (BSG) peptides with antioxidant and antihypertensive properties. The impact of hydrocolloids levels on peptide bioaccessibility was studied. Peptides were obtained from BSG using Purazyme and Flavourzyme enzymes. BSG peptides were fractionated by ultrafiltration (UF) and four fractions were obtained: F1 (>10 kDa), F2 (10-5 kDa), F3 (1-5 kDa), and F4 (<1 kDa). F3 showed the highest protein purity, ferulic acid content, proportion of amphipathic peptides, and bioactive properties (ABTS+ radical scavenging and ACE-I inhibitory activity). The identified peptides from F3 by tandem mass spectrometry were 138. In silico analysis showed that 26 identified peptides had ABTS+ inhibitory activity, while 59 ones presented good antihypertensive properties. The effect of XG and P levels on bioaccessibility of F3 peptides in the formulated beverages was studied by a central composite experimental design. It was observed that F3 peptides interacted with hydrocolloids by electrostatic forces at pH of formulated beverages. The addition of hydrocolloids to formulation modulated the release of the antioxidant peptides and protected the degradation of ACE-I inhibitory peptides from F3 during simulated gastrointestinal digestion. Finally, the level of hydrocolloids that produced intermediate viscosities in the formulated beverages improved the bioaccessibility of the F3 peptides.

Parboiling of sorghum grains as a strategy to improve endosperm yield and mineral content of refined flours.

The aims were (i) to optimize the parboiling/decorticating process by assessing the effects of parboiling soaking temperature (60-80 ℃) and pearling time (4-6 min and 5.5-9.5 min for red and white sorghum) on endosperm yield and ash content, to obtain pregelatinized refined flours from parboiling sorghum (RF-PS) and (ii) to evaluate the final content of selected nutrients in RF-PS obtained in these optimal conditions. Endosperm yield decreased with the increase of pearling time, and a maximum around 70 ℃ soaking temperature was observed. Ash content decreased with increasing soaking temperature and pearling time. The optimal conditions of soaking temperature-pearling time were 73.3 ℃-4.8 min for red sorghum and 67.9 ℃-8.6 min for white sorghum, considering maximum endosperm yield and ash content lower than 0.65 g/100 g. In RF-PS obtained under optimal conditions, protein, lipid, Cu, and free polyphenols were higher in red sorghum than white sorghum (10.16 ± 0.62 vs. 9.42 ± 0.61 g/100 g, 0.89 ± 0.16 vs. 0.62 ± 0.11 g/100 g, 2.08 ± 0.21 vs. 1.88 ± 0.20 mg/kg, 79.51 ± 14.51 vs. 63.82 ± 4.33 mg/100 g). Fe, Zn, Ca, and Na were higher in white sorghum than red sorghum (20.61 ± 2.92 vs. 17.56 ± 0.98 mg/kg, 11.94 ± 0.84 vs. 9.58 ± 1.65 mg/kg, 87.45 ± 12.91 vs. 75.31 ± 12.57 mg/kg, 129.62 ± 9.03 vs. 102.69 ± 28.34 mg/kg). No difference was observed in the contents of ash, Mg, and K. It was possible to improve endosperm yield using a parboiling process prior to decortication. In addition, this process contributes to increase the mineral content in RF-PS.

Nutritional improvement of corn pasta-like product with broad bean (Vicia faba) and quinoa (Chenopodium quinoa).

In this study, the nutritional quality of pasta-like product (spaghetti-type), made with corn (Zea mays) flour enriched with 30% broad bean (Vicia faba) flour and 20% of quinoa (Chenopodium quinoa) flour, was determined. Proximate chemical composition and iron, zinc and dietary fiber were determined. A biological assay was performed to assess the protein value using net protein utilization (NPU), true digestibility (TD) and protein digestibility-corrected amino acid score (PDCAAS). Iron and zinc availability were estimated by measuring dialyzable mineral fraction (%Da) resulting from in vitro gastrointestinal digestion. Nutritionally improved, gluten-free spaghetti (NIS) showed significantly increased NPU and decreased TD compared with a non-enriched control sample. One NIS-portion supplied 10-20% of recommended fiber daily intake. Addition of quinoa flour had a positive effect on the FeDa% as did broad bean flour on ZnDa%. EDTA increased Fe- and ZnDa% in all NIS-products, but it also impaired sensorial quality.

Germination and extrusion as combined processes for reducing phytates and increasing phenolics content and antioxidant capacity of Oryza sativa L. whole grain flours.

Whole rice (WR) products with low phytic acid (PA) content and enhanced bio-functional components were obtained by the combination of germination and extrusion processes. Germination conditions (24 h - 35 °C), with a previous soaking process (24 h - 20 °C), were chosen according to the remnant PA content and germination rate. Specific mechanical energy consumption, expansion, sensorial and mechanical hardness, specific volume, solubility, water absorption, free phenolic content (FPC) and antioxidant capacity were evaluated. Results indicated that 175 °C and 14 g 100 g(-1) of moisture were the most appropriate conditions to obtain expanded products and precooked flours based on germinated WR. Selected extruded product presented less PA content (821.6 9 ± 10.3 versus 695.2 0 ± 1.6 mg 100 g(-1)) and higher Fe bio-accessibility, FPC (45.2 9 ± 1.61 versus 66.3 5 ± 3.35 mg GAE g(-1)) and antioxidant capacity compared with WR (34.9 5 ± 0.8 versus 54.6 3 ± 1.6 µmol trolox g(-1)). Combining germination-extrusion processes could be a strategy to obtain expanded products or precooked flours based on WR with enhanced health benefits.

Composición y aporte potencial de hierro, calcio y zinc de panes y fideos elaborados con harinas de trigo y amaranto / Composition and potential contribution of iron, calcium and zinc of bread and pasta made with wheat and amaranth flours]

Amaranth, a traditional american crop that is nowadays given renewed importance, has good food potential value. The minerals contributed by the grain are quantitatively important. However, as the flour is obtained by total grinding of the grain, this process leads to the presence of anti-nutritional components, such as fitates, and therefore, the evaluation of the actual availability of the minerals of nutritional interest becomes necessary. The process of bread fermentation, plus the addition of fitases and enhancers of mineral availability such as citric and ascorbic acid, might improve mineral bioavailability. The objective of this work was to assess protein, ash, lipids and total dietary fiber content and evaluate the concentration and dialyzability of Fe, Zn and Ca (as mineral bioavailability indicator) in bread and pasta 100% wheat, and bread and pasta obtained by replacing 20% wheat flour (WF) with whole amaranth flour (WAF). Ascorbic acid (AA), citric acid (CA) and fitase were used as mineral bioavailability enhancers. The potential contribution of each mineral (PC) was calculated as each mineral concentration times its dialyzability. In 80:20 bread an increase of total dietary fiber and minerals, compared to 100% wheat products was observed. A maximum FePC in 80:20 bread was obtained with CA and fitase (0.55mg%). In pasta, the maximum effect was observed with CA (0.07 mg%). The CaPC was maximum in 80:20 pasta with CA (16.72 mg%). The greatest ZnPC was found in 80:20 bread with CA and fitase (0.40 mg%). The introduction of the WAF in fermented baked products with addition of CA and fitase allows to obtain nutritional advantages.

El amaranto es un cultivo americano autóctono actualmente revalorizado por su elevado potencial alimentario. Los minerales aportados por el grano son cuantitativamente importantes. Sin embargo, la presencia de fitatos en los tegumentos externos del grano hace necesaria la evaluación de la biodisponibilidad de los minerales de interés nutricional pues la harina se obtiene por molienda integral. El proceso de fermentación del pan, sumado al agregado de fitasas y promotores de la dializabilidad mineral, podría mejorar la biodisponibilidad mineral. El objetivo del trabajo fue establecer el porcentaje de proteínas, cenizas, lípidos, fibra dietaria total (FDT), Fe, Zn y Ca y estudiar la dializabilidad de esos minerales - como indicadora de su biodisponibilidad - en panes y fideos elaborados con 100% harina de trigo (HT) y con 20% de reemplazo de HT por harina integral de amaranto (HIA). Como promotores de la biodisponibilidad mineral se utilizaron ácidos ascórbico (AA) y cítrico (AC) y fitasa. Se estableció el aporte potencial (AP) de cada mineral como el producto de su concentración y dializabilidad. En los panes 80:20 se observó un incremento sustancial del contenido de FDT y minerales. El máximo APFe se obtuvo en panes 80:20 con AC y fitasa (0,55 mg%). En fideos, el máximo efecto se observó con AC (0,07 mg%). El APCa fue máximo en fideos 80:20 con AC (16,72 mg%). El mayor APZn se evidenció en pan 80:20 con AC y fitasa (0,40 mg%). La introducción de la HIA en productos panificados fermentados con adición de AC y fitasas permite obtener ventajas nutricionales.

Effect of the extrusion on functional properties and mineral dialyzability from Phaseolus vulgaris bean flour.

The effects of extrusion conditions on cooking degree, flour dispersion viscosity and mineral potential availability of extruded bean flour were studied. Phaseolus vulgaris beans of the agronomic cultivar "Flor de mayo" were ground and dehulled to obtain grits and then extruded at different temperatures (140, 160 and 180 degrees C) and moisture contents (17, 20 and 23%), according to a bifactorial experimental design. Degree of cooking was estimated by water solubility (WS) and specific mechanical energy (SME). The effect of variables on WS and SME were analysed by surface response methodology. Flour dispersion viscosity and mineral availability (estimated by in vitro dialyzability), were also evaluated on selected samples. Results showed that, within the ranges of the variables used for this study, only the effect of temperature was significant on the degree of cooking. No direct correlation was observed between water solubility and SME, although a maximum value of WS corresponded to a range of SME values of 400-500 J/g was observed. Dispersion viscosity decreases as WS increases, so if high calorie density is desired, for instance in order to produce a cream soup formula, bean grits should be extruded at high temperature and as low moisture as possible, in our case 180 degrees C and 17% moisture. On the other hand, the effects of extrusion variables on iron and zinc dialyzability were not much affected.

Chemical breakdown of technetium-99m DTPA during nebulization.

Aerosols of 99mTc diethylenetriaminepentaacetic acid ([99mTc]DTPA) used for measuring lung permeability and lung ventilation require a radioaerosol delivery system to produce an aerosol with reproducible size and radiochemical purity. To test how well nebulizers meet this requirement, radiochemical purity of aerosols produced with a jet and an ultrasonic nebulizer was evaluated. The activity median aerodynamic diameter (AMAD) and geometric standard deviation (sigma g) of radioaerosols were 0.46 micron (sigma g = 1.6) for the jet nebulizer and 0.70 micron (sigma g = 1.7) for the ultrasonic nebulizer. Paper and liquid chromatographic assays were obtained on the [99mTc]DTPA aerosol solute produced with each nebulizer. The results of these tests showed major differences in radiochemical purity. Aerosols produced in the jet nebulizer consistently showed greater than 90% of the radioactivity bound to the DTPA ligand whereas aerosols produced in the ultrasonic nebulizer showed less than 10% of the radioactivity bound to DTPA. The results support the need to test radiochemical purity of aerosols before using an aerosol nebulizer for pulmonary imaging and clearance studies.